Slide bottom acrylic cases for MOC

[wrighty]

What's the best way to secure them without actually glueing it? If unsecured the bottom piece keep falling out every time I move them. Listening to all ideas!!

 

[Stargeezer]

2 Tiny pieces of clear tape... Or sliding bottom cases where the bottom doesnt fall out like that...

 

[plantman]

bit of masking tape, doesn't leave any glue residue either.

 

[Bramistuta25]

I use the force...

 

[JuniorChubb]

:lol: :lol: :lol:

 

[Captainsolo1978]

2 Tiny pieces of clear tape... Or sliding bottom cases where the bottom doesnt fall out like that...

I agree. It's invisible.

 

[x-pack]

Couple of drops of pva glue would do it. Just a tiny amount somewhere out of sight would hold and it should be reversible should you wish to take the card out.

 

[wrighty]

Couple of drops of pva glue would do it. Just a tiny amount somewhere out of sight would hold and it should be reversible should you wish to take the card out.

Thanks guys for the advice and recommendations. I do like the drop of glue idea instead of tape, cheers Barry!!

 

[lee gray]

I always use sellotape.
Always thought its a bit silly having the slider at the botton as if that opens, out slides the card, sellotape holds it firm, at one time i actually put my carded figure in upside down so the slider was at the top...

 

[Stargeezer]

That is what i liked about Oscar's cases, the sliding bottom was a nice thight fit and the sorta clicked at the last millimeters, wich kept them firmly in place.

 

[wrighty]

That is what i liked about Oscar's cases, the sliding bottom was a nice thight fit and the sorta clicked at the last millimeters, wich kept them firmly in place.

I like them too but will be too much hassle to buy from US. The OCD in me will need to keep all the cases the same. :lol: