revolving display case

[han duo]

i got the templates fromm frunkstar and printed them on photo gloss paper (which was sticky back ), there is room uner each figure to put a name plate (which ive got the figures names from a repro sheet which went with the c3po figure case) ive not put the figure names in place yet as iam not sure which figures to put in as there is only room for 16 , it looks realy cool as it rotates (if anyone knows how i can place a link with video footage then i will)..anyway ive got two ! and i may beable to get some more!! what do you guys think!

 

[jabbawokkie]

looks great but wont that light murder them stormtroopers

 

[han duo]

you dont have to have the light on, its got a starter which you can remove so it will turn without the light.if i was to sell one what do you think would be a fair price?

 

[boba frett]

I would think it be difficult to sell due to it holding very few figures.

Good effort though!

 

[han duo]

i could advertise it as a "last 16 figure stand" :lol:



or what about holding variations.........a few han hoths maybe?

 

[han duo]

just had a bit of a play......

 

[Frunkstar]

Looks ok but I would rip all that central **** out & pop some shelfs in :wink:

 

[PhantomShadow]

agreed - does that middle bit come out?
It might be better for displaying something bigger like GG statue or something along those lines

 

[gustie]

maybe you could rip the inner out and fit a chromed pole in the middle so it can still rotate, you could get some clear disks and glue them up the length of pipe and then you could add LOADS of figures

 

[han duo]

maybe you could rip the inner out and fit a chromed pole in the middle so it can still rotate, you could get some clear disks and glue them up the length of pipe and then you could add LOADS of figures

i tryed , if i rip it out then the motor would have to go ! ............i could rip it out and place a stand in it for the 12" figures ??? i might do that next....( IVE GOT ABOUT 6-8 CASES).................I WILL KEEP YOU ALL POSTED !

 

[gustie]

get a coping saw on it and just leave the stubs on each end and connect a new pole to it